Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
2000 Yamaha 150hp 25” shaft length outboard motor model 150TXRY. Last of the super reliable 2 stroke carburated light weight motor only 415lbs. Motor has oil injected and also has power tilt and trim.
Motor runs excellent, solid 115-120lbs compression and looks very nice. Tilt and trim works fine and lower unit is free of water and metal shavings.
Motor with only 421 hours
$2,000
Only logged in customers who have purchased this product may leave a review.
HIS IS A 6 CYL, 2.5 LITER, CARBURETED OUTBOARD WITH POWER TRIM AND TILT. THESE MERCURY 150 OUTBOARDS PRODUCE OUTSTANDING POWER AND ARE BOTH SUPER RELIABLE AND VERY DURABLE. THIER LOW END TORQUE IS SECOND TO NONE.
MECHANICALLY YOU COULDN’T ASK FOR MORE. THE COMPRESSION WAS 115-120 ON ALL CYLINDERS. IT FIRES RIGHT UP, PUMPS GOOD WATER, SHIFTS SMOOTH AND SOUNDS EXCELLENT WHEN YOU RAP THE THROTTLE.
2002 Nissan 70hp outboard motor. Standard 20” shaft length with power tilt and trim and desirable oil injection. Last of the super reliable, simple and light weight 2 stroke motor.
This is a reliable made in Japan Nissan power for little money. Basically same reliability and design of the Yamaha 70hp of its time without the Yamaha pricing.
Motor runs strong with 125lbs compression on all 3 cylinders. Tilt and trim works fine and lower unit is free of water and metal shavings. This is a nice used motor which should serve it next owner well if properly cared for.
Clean Used 2002 Evinrude 200 HP V6 DFI 2 Stroke 20″ (Long Shaft) Outboard Motor. Model number: E200FPLSNF. Weight – 514 lbs. 130-135 psi compression on all 6 cylinders. Midsection has been replaced, so ID tag does not match the rest of the motor. New Impeller, Gear Oil, and Spark Plugs. Electric Start. Power Tilt/Trim.
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.