Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Used 2013 Mercury 225XL 25inch DFI OPTIMAX 2 STROKE OUTBOARD in good running condition.
Mercury Optimax engines are sequential Direct Fuel Injection 2 stroke engines. This makes them very fuel efficient.
Hours: 316
Cylinders: 6
Weight 525lbs
Shaft Length: 25″
Compression Range:
#1-110psi #2-110 psi
#3-120 psi #4-130psi
#5-110 psi #6-120psi
$2,500
Only logged in customers who have purchased this product may leave a review.
2003 Honda 225HP 4 Stroke Outboard Engine 25 Shaft
515 Hours
The Outboard engine comes with controls, gauges, wiring harness and propeller.
The Outboard Motor is working perfectly in good conditions with 3 months warranty, Motor has been inspected and ready to mount and run.
Clean Used 2002 Evinrude 200 HP V6 DFI 2 Stroke 20″ (Long Shaft) Outboard Motor. Model number: E200FPLSNF. Weight – 514 lbs. 130-135 psi compression on all 6 cylinders. Midsection has been replaced, so ID tag does not match the rest of the motor. New Impeller, Gear Oil, and Spark Plugs. Electric Start. Power Tilt/Trim.
used 1999 Mercury 225hp 20in long shaft remote outboard
Year: 1999
Make: Mercury
Model: 225hp Remote
Serial# 0G898956
Shaft length: 20in Long
Stroke: 2 stroke
This motor was just serviced
-Compression: 100PSI on all 4 cylinders
-Lower unit pressure tested good
-Fuel filter cleaned
-New spark plugs
-New impeller
-New lower unit lube
Hours: 780
Comes with prop and control box
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.