Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
2007 Yamaha 250 4 Stroke F250. Condition is “Used”.715 hours, comes with full rigging and gauges. 25” runs flawless.
The engine comes with controls, gauges, wiring harness and prop.
Buy with confidence all our used engines are inspected/ serviced by qualified marine technicians and ready to mount and run with a three month mechanical warranty.
$3,300
Only logged in customers who have purchased this product may leave a review.
200 hp Yamaha hpdi 2000
25 inch shaft
Good running motor
Lower unit oil is clean
Trim works great
Compression reading is110 110 110 110 110 110 psi
This motor have service period
This motor included prop and control
2002 Nissan 70hp outboard motor. Standard 20” shaft length with power tilt and trim and desirable oil injection. Last of the super reliable, simple and light weight 2 stroke motor.
This is a reliable made in Japan Nissan power for little money. Basically same reliability and design of the Yamaha 70hp of its time without the Yamaha pricing.
Motor runs strong with 125lbs compression on all 3 cylinders. Tilt and trim works fine and lower unit is free of water and metal shavings. This is a nice used motor which should serve it next owner well if properly cared for.
Clean Used 2002 Evinrude 200 HP V6 DFI 2 Stroke 20″ (Long Shaft) Outboard Motor. Model number: E200FPLSNF. Weight – 514 lbs. 130-135 psi compression on all 6 cylinders. Midsection has been replaced, so ID tag does not match the rest of the motor. New Impeller, Gear Oil, and Spark Plugs. Electric Start. Power Tilt/Trim.
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.