Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
This 1999 Mercury 115 ELPTO 2 stroke motor is a great motor to re-power with, is in great condition and has done 745 hours. It has a 20 inch shaft, and comes with remotes, cables and gauges. The motor also has a permatrim fitted and a s/s high five prop.
$2,100
Only logged in customers who have purchased this product may leave a review.
2003 Suzuki 150hp 25in remote 2 stroke outboard motor
Year: 2003
Make: Suzuki
Model: 150hp Remote
Serial# 15003-371585
Shaft length: 25in X-Long
Stroke: 2 stroke
This motor was just serviced:
-Compression: 100PSI on all 6 cylinders
-Lower unit pressure tested good
-New fuel filter
-New spark plugs
-New impeller
-New lower unit lube
-Cleaned fuel system
Hours: N/A
Comes with prop and conceal mount control box with warming gauge
Does not come with throttle/shift cables
2003 Honda 225HP 4 Stroke Outboard Engine 25 Shaft
515 Hours
The Outboard engine comes with controls, gauges, wiring harness and propeller.
The Outboard Motor is working perfectly in good conditions with 3 months warranty, Motor has been inspected and ready to mount and run.
2002 Nissan 70hp outboard motor. Standard 20” shaft length with power tilt and trim and desirable oil injection. Last of the super reliable, simple and light weight 2 stroke motor.
This is a reliable made in Japan Nissan power for little money. Basically same reliability and design of the Yamaha 70hp of its time without the Yamaha pricing.
Motor runs strong with 125lbs compression on all 3 cylinders. Tilt and trim works fine and lower unit is free of water and metal shavings. This is a nice used motor which should serve it next owner well if properly cared for.
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.